These are the steps to changing bearings on a harbor cargo scroll saw.
1. Unplug The Saw
Before you begin any maintenance or repair, always unplug your saw.
2. Take Out The Screws
Take out the screws holding the lower and upper blade guards in their place.
3. Take Off The Upper Blade Guard.
After the screws have been removed, lift the upper blade guard up and place it aside.
4. Take Out The Lower Blade Guard
Take out the screws holding it in place, and then set it aside.
5. Take Out The Old Bearings.
You can now remove the old bearings from the housing. You will usually find three to four bearings total. These can be pulled out using your fingers, a small screwdriver, or pliers.
6. Replace Bearings
Push the bearings into the housing until fully seated. Before installing bearings, it is important that they face in the same direction.
7. Install The Lower Blade Guard.
You can re-install the lower blade protector by following the same steps as before. You must tighten the screws to secure it in place.
8. Install The Upper Blade Guard.
You can reinstall the upper blade guard using the same steps as you did to remove it. Make sure the screws are securely fastened.
9. Test The Plugin Saw:
Test the saw by plugging it in and running it. Congratulations! You have just changed the bearings of your Harbor Freight scrollsaw.
Identify Bearings That Need Replacing:
Harbor Freight scrollsaw bearings that need replacing are often noisy or difficult to turn.
For assistance, contact the manufacturer if you are unsure which bearings should be replaced.
FAQs:
What Bearings Should I Change On My Harbor Freight Scrollsaw?
Any standard-sized bearing can be used to replace the bearings of your Harbor Freight scrollsaw.
How Can I Replace The Bearings Of My Harbor Freight Scroll Saw?
You can replace the bearings of your Harbor Freight scrollsaw yourself. It’s very easy and takes only a few minutes.
Where Can You Find Replacement Bearings To Your Harbor Freight Scroll Saw’s Shaft?
You can find replacement bearings for Harbor Freight scrollsaws at any hardware store or online. Be sure to order the right size bearings before you buy them.
How Frequently Should I Change The Bearings Of My Harbor Freight Scroll Saw’s Shaft?
It is recommended to replace the bearings of your Harbor Freight scrollsaw every year, depending on how frequently you use it.
What Type Lubricant Should You Use For New Bearings?
It is essential to use a high-quality lubricant when installing bearings. This will help to keep them running smoothly.
Motor oil is a good choice. It can be found at most hardware stores. Apply a little motor oil to the bearings prior to reinstalling them. This will reduce friction and help keep your saw running as new.
What Do I Do If My New Bearings Aren’t Working?
It is possible that the bearings are not working correctly after installation. If this is the case, contact the manufacturer for assistance.
Conclusion:
Bearings are an essential part of any scroll-saw. These simple instructions will help you change them. This will not only keep your saw running smoothly but will also prolong the life of your machine. Don’t wait to replace your worn bearings!
